![]() Note: Once you’ve connected by clicking the “Connect” button, you’ll see a toggle for “Expert mode”. Remove the short circuit from the BOOT pins, and you are ready to set things up. It’ll take a few seconds, and if all goes well, you should have Betaflight(whichever version) loaded onto your board. ![]() If you’ve entered the BOOT mode correctly, the next step is to select the correct board and firmware, click the Load Firmware(Online) button, and then click the flash button. This will be different from board to board, so you’ll have to consult your manual. If you shorted the pins correctly, the LEDs that normally flash on your board when you plug it in will not turn on, and instead there will be just one LEDs. ![]() In order to flash Betaflight, you may first need to short the “BOOT” pins on your board and then connect the USB into your computer.
0 Comments
Leave a Reply. |